i-80 Torque Calibrator

Description

i-80 Torque Calibrator for Electric Drivers.
i-80 Torque Calibrator for Electric Drivers
69.70 lbf-in Capacity
Torque Calibrators for Power Drives & Wrenches
Standard Features
Wide measuring range up to 70 lbf-in
Selectable units lbf-in, Kgf-cm, N-cm and N-m
Programmable High/Low setpoints with audible beep for uniform torque tightening or GO/NO GO testing
2 – driver adapters included: i-80 comes with smart adapters
Peak, Real Time and Peak Down measuring modes (selectable)
Measure both clockwise and counterclockwise
USB virtual COM port sends peak (1 data) or continuous data (12 or 180 data/second)
Statistics: number of data, Max, Min, Avg
Heavy-duty metal construction
Runs on internal NiMH batteries or AC adapter
3/8″ drive for socket wrenches
The Cedar i-80 torque calibrator measures the peak torque non-impact electric/air drivers apply to a screw. Under tightened bolts and screws do not generate sufficient clamp force and can lead to loosening and assembly failure. Over tightening, past the yield point, permanently deforms the screw joint and can also lead to failure which is why proper tightening torque is so important. Manual torque wrenches can also be calibrated.
Unique Smart Adapters
The unique Smart Adapters simulate the screw joint and do not need to be backed-off after each test. This features increases testing efficiency and ease of use by reducing the time between each test. Results can be downloaded through the USB port for analysis with data acquisition software. The Series i torque calibrators are compatible with Imada’s SW-1SV-USB software.
The peak torque or peak down torque in breakaway tests is captured automatically. The Cedar Series i torque calibrator displays Max, Min and Avg statistics. The tester can read values in lbf-in, kgf-cm, N-cm and  N-m.